Fluke 199B - Performance Verification

4-1
Chapter 4
Performance Verification
Title Page
4.1 Introduction.................................................................................................. 4-3
4.2 Equipment Required For Verification ......................................................... 4-3
4.3 General Instructions..................................................................................... 4-3
4.4 Operating Instructions.................................................................................. 4-4
4.4.1 Resetting the test tool ........................................................................... 4-4
4.4.2 Navigating through menu’s .................................................................. 4-4
4.4.3 Creating Test Tool Setup1.................................................................... 4-5
4.5 Display and Backlight Test.......................................................................... 4-5
4.6 Scope Input A&B Tests ............................................................................... 4-7
4.6.1 Input A&B Vertical Accuracy Test ...................................................... 4-7
4.6.2 Input A&B DC Voltage Accuracy Test................................................ 4-9
4.6.3 Input A&B AC Voltage Accuracy Test (LF) ....................................... 4-11
4.6.4 Input A & B AC Coupled Lower Frequency Test............................... 4-12
4.6.5 Input A and B Peak Measurements Test.............................................. 4-13
4.6.6 Input A&B Frequency Measurement Accuracy Test ........................... 4-14
4.6.7 Input A&B Phase Measurements Test.................................................. 4-15
4.6.8 Time Base Test ..................................................................................... 4-16
4.6.9 Input A Trigger Sensitivity Test........................................................... 4-17
4.6.10 Input A AC Voltage Accuracy (HF) & Bandwidth Test .................... 4-19
4.6.11 Input B Trigger Sensitivity Test ......................................................... 4-20
4.6.12 Input B AC Voltage Accuracy (HF) & Bandwidth Test .................... 4-21
4.6.13 Video test using the Video Pattern Generator .................................... 4-22
4.6.14 Video test using SC600 Scope Calibration Option ............................ 4-24
4.7 External Trigger Level Test ......................................................................... 4-27
4.8 Meter (DMM) Tests..................................................................................... 4-28
4.8.1 Meter DC Voltage Accuracy Test ........................................................ 4-28
4.8.2 Meter AC Voltage Accuracy & Frequency Response Test ................. 4-29
4.8.3 Continuity Function Test...................................................................... 4-30
4.8.4 Diode Test Function Test ..................................................................... 4-30
4.8.5 Ohms Measurements Test .................................................................... 4-30
4.9 Probe Calibration Generator Test ................................................................ 4-32