Fluke 233 - Safety Information

233
Getting Started Manual
2
Safety Information
The Meter complies with:
• ISA-82.02.01
• CAN/CSA C22.2 No. 61010-1-04
• ANSI/UL 61010-1:2004
• EN 61010-1:2001
• EN 61326-1:2006
• EN 61326-2-2:2006
• ETSI EN 300 328 V1.7.1:2006
• ETSI EN 300 489 V1.8.1:2008
• FCC Part 15 Subpart C Sections 15.207,
15.209, 15.249 FCCID: T68-F233
• RSS-210 IC: 6627A-F233
• Measurement Category III, 1000V, Pollution
Degree 2
• Measurement Category IV, 600V, Pollution
Degree 2
In this manual, a Warning identifies the conditions and
procedures that cause a dangerous situation to the user.
A Caution identifies the conditions and procedures that
could cause damage to the Meter, equipment under test
damage, or permanent data loss.
The symbols used on the Meter and in this manual are
shown in Table 1.
XWWarning
To prevent possible electrical shock or
personal injury, follow these guidelines:
• Use this Meter only as specified in this
manual or the protection can be
compromised.
• Do not use the Meter if it is damaged.
Before you use the Meter, examine the
case. Look for cracks or missing plastic.
Carefully look at the insulation around
the terminals.
• Make sure the battery door is closed and
locked before you operate the Meter.
• Replace the batteries when the battery
indicator () appears.