Model 16 English Instruction Sheet
Page
1
®
16
Multimeter with Temperature
Instruction Sheet
P
Read First: Safety Information
To ensure that the meter is used safely, follow these instructions:
• Do not use the meter if the meter or test leads appear damaged, or if
you suspect that the meter is not operating properly.
• Disconnect the live test lead before disconnecting the common test
lead.
• When using the probes, keep your fingers behind the finger guards on
the probes.
• Do not use the V•Check
mode to measure voltages in circuits that
could be damaged by this mode's low input impedance
(≅2 kΩ).
• Turn off power to the circuit under test before cutting, desoldering, or
breaking the circuit. Small amounts of current can be dangerous.
• Do not apply more than 600V rms between a meter terminal and earth
ground.
• Use caution when working with voltages above 60V dc or 30V ac rms.
Such voltages pose a shock hazard.
PN 2063513 December 2002 Rev.1, 9/04
2002,2004 Fluke Corporation. All rights reserved. Printed in China
To Next Page
Need help?
General
