Fluke 287 Calibration Manual

287/289
Calibration Manual
2
Address correspondence to:
Fluke Corporation Fluke Europe B.V.
P.O. Box 9090, P.O. Box 1186,
Everett, WA 98206-9090 5602 BD Eindhoven
USA The Netherlands
Visit us on the World Wide Web at: www.fluke.com
Precautions and Safety Information
XWWarning
To avoid possible electric shock or personal injury, use this
Meter only as specified in this manual or the protection
provided by the Meter might be impaired.
Read the “Safety Information” page before servicing this product.
In this manual, a Warning identifies conditions and actions that pose hazard(s) to the
user; a Caution identifies conditions and actions that may damage the Meter or the test
instruments.
International Symbols
International symbols used on the Meter and in this manual are explained in Table 1.
Table 1. Symbols
Symbol Description Symbol Description
B AC (Alternating Current or Voltage) I Fuse
F DC (Direct Current or Voltage)
T
Double Insulated
X
Hazardous voltage
W
Important Information; refer to manual
E
Battery (Low battery when shown on
the display)
J Earth ground
R
Continuity test or continuity beeper
tone
$
Conforms to relevant Canadian and
US standards
P
Conforms to European Union
directives
;
Conforms to relevant Australian
standards
t
Underwriters Laboratory listed
product
s
Inspected and licensed by TÜV
Product Services
CAT III
IEC Measurement Category III – CAT
III equipment is designed to protect
against transients in equipment in
fixed equipment installations, such as
distribution panels, feeders and short
branch circuits, and lighting systems
in large buildings.
CAT IV
IEC Measurement Category IV – CAT
IV equipment is designed to protect
against transients from the primary
supply level, such as an electricity
meter or an overhead or underground
utility service.
~
Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for
recycling information.
Safety Information
The Meter complies with:

Fluke 287 Specifications

General

Data hold	Yes
Product type	Digital multimeter
Product color	Grey, Yellow
Frequency range	0 - 999.99 kHz
DC current range	0 - 10 A
DC voltage range	0 - 1000 V
Resistance range	0 - 500000000 Ω
Capacitance range	0 - 100000 nF
Resolution (AC voltage)	0.001 mV
Basic accuracy (frequency)	0.005%
Basic accuracy (DC current)	0.05%
Basic accuracy (DC voltage)	0.025
Temperature measurement range	-200 - 1350 °C
Battery type	AA
Power source	Battery
Battery technology	Alkaline
Number of batteries supported	6
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	0 - 90 %
Display digits	4.5 digits

Weight and Dimensions

Depth	60 mm
Width	102 mm
Height	222 mm
Weight	870.9 g