2
Clamp Meter
Safety
Safety
General Safety Information is in the printed Safety Information document that ships with the Product
and at www.uke.com. More specic safety information is listed where applicable.
A Warning identies conditions and procedures that are dangerous to the user. A Caution identies
conditions and procedures that can cause damage to the Product or the equipment under test.
Before You Start
Battery
XW
Warning
To prevent personal injury and for safe operation of the Product:
• The battery door must be closed and locked before you operate the Product.
• Remove all probes, test leads, and accessories before the battery door is opened.
• Replace the batteries when the low battery indicator shows to prevent
incorrect measurements.
• When batteries are changed, ensure that the calibration seal in the battery compartment
is not damaged. If damaged, the Product may not be safe to use. Return the Product to
Fluke for replacement of the seal.
W
Caution
To prevent damage to the battery:
• Repair the Product before use if the battery leaks.
• Do not expose battery to heat sources or high-temperature environments such as an
unattended vehicle in the sun.
• Always operate in the specied temperature range.
• Do not incinerate the Product and/or battery.
The Product ships with the batteries. To replace batteries, see Figure 1.
Figure 1. Battery Replacement
AAA
To Next Page
Loading...
Need help?
General
