Fluke 319 Instructions

6
Software Specifications

Earth ground

Alternating current

Direct current

Conforms to European Union directives.

Measurement Category II is applicable to test and
measuring circuits connected directly to utilization
points (socket outlets and similar points) of the low-
voltage MAINS installation.

Measurement Category III is applicable to test and
measuring circuits connected to the distribution part
of the building’s low-voltage MAINS installation.

Measurement Category IV is applicable to test and
measuring circuits connected at the source of the
building’s low-voltage MAINS installation.

This product complies with the WEEE Directive
marking requirements. The affixed label indicates that
you must not discard this electrical/electronic
product in domestic household waste. Do not dispose
of this product as unsorted municipal waste.
Calibration Full manual calibration and test
One-year calibration cycle
Data Integrity and
Security
Calibration parameters stored in flash
ROM
Symbol Description

Fluke 319 Specifications

General

Category	Clamp Meter
AC Voltage Range	0.1 V to 600 V
DC Voltage Range	0.1 V to 600 V
Continuity	≤ 30 Ω
Safety Rating	CAT III 600 V
Battery Type	2 x AAA
AC Voltage Accuracy	±1.5% + 5 digits
Display	LCD
AC Current Accuracy	±2% ±5 digits
DC Current Accuracy	±2% ±5 digits