Battery Replacement
If battery voltage drops below the operating voltage, the battery
symbol (M) appears on the display. If this happens, replace the
battery as soon as possible.
XW Warning
There is risk of electric shock during battery
replacement. Always remove the Clamp Meter from
measurable conductors under test before replacing
the battery.
Always use the correct replacement battery.
To replace the battery, see Figure 3:
1. Make sure the power is off.
2. Place the Clamp Meter on its face and turn the battery cover
counter clockwise using a Phillips screwdriver.
3. Remove the cover and the installed battery.
4. Replace the battery, making sure that the polarity is correct.
5. Reinstall the battery cover, turn it clockwise and reinstall the
screw.
A B
epq003.eps
A Insert the battery ensuring the polarity is correct.
B Close the battery cover, aligning the arrow’s tail with the
dot and then turn clockwise
Figure 3. Changing the Battery
General Specifications
Measurement functions AC current
Additional functions Data hold and Auto power-off
Display (LCD) Digital reading : 3200 counts
Bar Graph: 32 segments
“OL” over-range indication
Low-battery symbol
Range Selection Automatic
Sampling Digital reading: 2 times/sec
Bar graph: 12 times/sec
Operating temperature
and humidity range
0 to 50 °C, with a maximum
humidity of 80 % RH
(no condensation)
Storage temperature and
humidity range
-20 to 60 °C, with humidity range
20 to 70 % RH
(no condensation)
Temperature Coefficient ± 0.05 % of measuring range/°C
(< 18 °C or > 28 °C).
Measuring range: 0 to 50 A
0.0005 % typical value (in terms
To Next Page
Loading...
