17
Command Summary (cont)
Oscilloscope Commands (cont)
TLIMIT_D? Returns the power-up and reset
default for the time limit for
-SC600 OVERLD mode to stay
in operate.
TMWAVE Selects the waveform for
MARKER mode.
TMWAVE? Returns the timemark waveform
setting for MARKER mode.
TRIG Sets the frequency of the signal
at the TRIG OUT BNC.
TRIG? Returns the frequency of the
signal at the TRIG OUT BNC.
VAL? Returns the last thermocouple,
pressure, or, for the -SC600,
impedance measurement value.
VIDEOFMT Selects the format for VIDEO
mode.
VIDEOFMT? Returns the VIDEO mode format.
VIDEOMARK Sets the VIDEO mode line
marker location.
VIDEOMARK? Returns the VIDEO mode line
marker location.
ZERO_MEAS Zeros the pressure module or
sets the zero offset for
capacitance measurement using
the -SC600.
ZERO_MEAS? Returns the zero offset for the
pressure module or capacitance
measurement using the -SC600.
To Next Page
Loading...
