20
Command Summary (cont)
Output Commands (cont)
WAVE Sets waveforms for ac outputs.
WAVE? Returns output waveform.
ZCOMP Activates or deactivates
impedance compensation.
ZCOMP? Returns status of impedance
compensation.
Pressure Measurement Commands
DAMPEN Activates or deactivates
dampening (averaging) of
pressure readings.
DAMPEN? Returns whether dampening
(averaging) of pressure readings
is active.
PRES? Queries the attached pressure
module for its model and serial
number.
PRES_MEAS Changes the operating mode to
pressure measurement.
PRES_UNIT Sets the pressure display units.
PRES_UNIT? Returns the pressure display
units.
VAL? Returns last pressure
measurement.
ZERO_MEAS Zeros the pressure module or
sets the zero offset for
capacitance measurement using
the -SC600.
ZERO_MEAS? Returns the zero offset for the
pressure module or capacitance
measurement using the -SC600.
To Next Page
Loading...
