16
Command Summary (cont)
Oscilloscope Commands
See Chapter 8 of the 5520A Operators Manual for
usage information.
OL_TRIP? Returns the detected state of
scope overload protection.
OUT_IMP Sets the output impedance of
the SCOPE BNC.
OUT_IMP? Returns the output impedance
of the SCOPE BNC.
RANGE Sets the 5520A range when in
OVERLD, PULSE, or MEASZ
scope modes.
SCOPE Sets the calibrator output to an
oscilloscope mode.
SCOPE? Returns the present
oscilloscope mode.
TDPULSE Activates or deacvitates the
tunnel diode pulser drive for
the -SC600 EDGE mode.
TDPULSE? Returns whether the tunnel
diode pulser drive for the
-SC600 EDGE mode is active.
TLIMIT Sets the time limit for -SC600
OVERLD mode to stay in
operate.
TLIMIT? Returns the time limit for
-SC600 OVERLD mode to
stay in operate.
TLIMIT_D Sets the power-up and reset
default for the time limit for
-SC600 OVERLD mode to
stay in operate.
To Next Page
Loading...
