19
Command Summary (cont)
Output Commands (cont)
PHASE Sets phase for dual outputs.
PHASE? Returns phase output.
POWER? Returns power for power
outputs.
RANGE? Returns output ranges.
RANGELCK Locks range or set autorange.
RANGELCK? Returns locked or autorange.
REFCLOCK Sets the reference clock source
(internal or through the 10 MHz
IN BNC connector).
REFCLOCK? Returns the reference clock
source (internal or through the
10 MHz IN BNC connector).
REFPHASE If two 5520As are synchronized
using 10 MHz IN/OUT, sets the
phase difference between the
NORMAL terminals on the slave
5520A and the NORMAL
terminals on the master 5520A.
REFPHASE? If two 5520As are synchronized
using 10 MHz IN/OUT, returns
the default phase difference
between the NORMAL terminals
on the slave 5520A and the
NORMAL terminals on the
master 5520A.
STBY Puts 5520A in standby.
SYNCOUT Sends a synchronization pulse
out to a slave 5520A through the
10 MHz OUT BNC connector.
To Next Page
Loading...
