Fluke 5730A - Specialty Piston Gauges; Manual Pressure Generation and Control

PG9607/ PG9602
OPG1
700HPPK
MPG2
GPC1
National
Metrology
Institute
piston gauges
PG9607 Gas Piston Gauge
Fully automated primary pressure
reference for absolute and gauge
pressures to 500 kPa.
• Gauge and absolute pressures
from 11 kPa to 500 kPa with a
single piston-cylinder
• Large diameter 50 mm piston-
cylinder with improved geom-
etry allows direct traceability
to dimensional measurements
with very low uncertainties
PG9602 Gas Piston Gauge
Fully automated primary pressure
reference for absolute and gauge
pressures to 11 MPa.
• Gauge and absolute pressures
from 10 kPa to 11 MPa
• Up to 100 kg mass load under
vacuum bell jar for large
turndown and overlap of
piston-cylinder ranges
Manual pressure
generation
and control
3990 Gas Pressure
Control Pack
Precise, manual absolute and
gauge pressure control for gas
piston gauges and indicators.
• Models from vacuum to 7 MPa
and 20 MPa (1,000 psi and
3,000 psi)
• Self-contained for intuitive,
easy use
GPC1 High Gas
Pressure Controller
Precise, assisted manual control
for high pressure gas piston
gauges and indicators.
• Models to 70 MPa and 110 MPa
(10 k psi and 16 k psi)
• Precise control to full pressure
with simple, ergonomic push-
button operation
MPG2 Hydraulic Pressure
Generator/Controller
Precise, manual control for
hydraulic piston gauges and
indicators.
• Models to 100 MPa and
200MPa (15 k psi and
30 k psi)
• Self-contained for intuitive and
easy generation and
precise control to full pressure
OPG1 Hydraulic Pressure
Generator/Controller
Precise, assisted manual control
for hydraulic piston gauges and
indicators.
• Pressure to 200 MPa (30 k psi)
• Precise generation and control
to full pressure with simple,
ergonomic push-button
3990
700HPPK Pneumatic
Test Pump Kit
Generate 21 MPa (3,000 psi)
easily in the field, without liquid
contamination or the hazard of a
pressurized gas cylinder
• Generate and adjust pneumatic
pressures up to 21 MPa
(3,000 psi)
• Rugged, portable and stable
enough to go anywhere—on
any surface
• Reaches pressure in 20
seconds to full scale into a
30 cm
3
volume
• Detachable pressure adjust-
ment system for adjusting
pressure, connecting reference
and test devices on bench and
in the field, and isolating and
venting pressure
www.flukecal.com
35
Pressure calibration