Fluke 6070A - Power Source

Table 1-3. 6070A/6071A Specifications (cont)
Conducted and Radiated
Interference .
<3 uV induced in a 2 turn, 1-inch loop that is 1 inch
from any surface and measured into a 50 Ohms
receiver. Complies with RE02 and CEOS of MIL-
STD-461A, sections 4.3.1 and 4.3.2 of MIL-1-6181D.
both narrow and broad band.
Size .
width height depth
43 cm 13.3 cm 54.6 cm
17 inches 5.25 inches 21.5 inches
Weight .
28 kg (61 lbs.)
Power .
100. 120, 200, and 240V ac ±10%, 47 to 63 Hz.
Protection Class .
OPTIONS
Class 1 (as defined in lEC 348)
607XA-130 Oven Reference Option
FREQUENCY .
10 MHz
AGING RATE .
<±5 X 10-’°/day, after a 21 day warmup.
TEMPERATURE STABILiTY ....
<±2 X 10-’V°C.
POWER .
607XA-570 Non-Voiatiie Memory
Option
On during standby operation (STBY indicator on).
NUMBER OF LOCATIONS.
50
STORAGE TIME.
With power removed, the contents will be retained
for about 4 years.
POWER SOURCE .
Instrument power supply, operating or in standby.
Battery when power is removed.
POWER-ON CONDITION .
607XA-830 Rear RF Output Option
(replaces the front panel RF
OUTPUT connector)
Instruments with this option return the front panel to
the setup that existed when the instrument was
placed in standby or was turned off.
SPECIFICATIONS .
. Same as standard instrument.
CONNECTOR ..
. Type N, rear panel RF OUT connector.
607XA-831 Auxiliary RF Output
upnon
FREQUENCY .
. Same as RF output frequency.
AMPLITUDE .
>-18 dBm for normal autoranging operation.
IMPEDANCE .
. 50 Ohms, nominal.
CONNECTOR .
. BNC, rear panel AUX OUT connector.