Fluke 62 MAX Calibration Information

62 Max/62 Max +
Calibration Information
2
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user. A Caution identifies conditions and
procedures that can cause damage to the Product or the equipment under test.
The symbols used on the Product and in this manual are shown in Table 1.
Warning
To prevent eye damage and personal injury:
• Read all safety Information before you use the Product.
• Do not use the Product if it operates incorrectly.
• Use the Product only as specified, or the protection supplied by the
Product can be compromised.
• Before you use the Product, inspect the case. Do not use the Product if it
appears damaged. Look for cracks or missing plastic.
• See emissivity information for actual temperatures. Reflective objects
result in lower than actual temperature measurements. These objects pose
a burn hazard.
• Do not look directly into the laser with optical tools (for example,
binoculars, telescopes, microscopes). Optical tools can focus the laser and
be dangerous to the eye.
• Do not look into the laser. Do not point laser directly at persons or animals
or indirectly off reflective surfaces.
• Replace the batteries when the low battery indicator shows to prevent
incorrect measurements.
• Do not use the Product around explosive gas, vapor, or in damp or wet
environments.
• Use the Product only as specified or hazardous laser radiation exposure
can occur.
Table 1. Symbols
Symbol Meaning Symbol Meaning

Risk of danger.
Important information.
See Manual.

This product complies with the WEEE Directive
(2002/96/EC) marking requirements. The affixed label
indicates that you must not discard this
electrical/electronic product in domestic household
waste. Product Category: With reference to the
equipment types in the WEEE Directive Annex I, this
product is classed as category 9 "Monitoring and Control
Instrumentation” product. Do not dispose of this product
as unsorted municipal waste. Go to Fluke’s website for
recycling information.
 Warning. Laser.  Conforms to European Union directives.
 Battery  Conforms to relevant Australian standards.
Conforms to China
Metrology Certification
 Conforms to relevant South Korean EMC standards.

Fluke 62 MAX Specifications

General

Type	Infrared environment thermometer
Purpose	Outdoor
Placement	Hand
Display type	Digital
Product color	Yellow
Display form factor	Rectangular
International Protection (IP) code	IP54
Accuracy	1 °C
Response time	500 ms
Spectral response	8 - 14 µm
Min/Max temperature memory	Yes
Temperature measurement range	-30 - 500 °C
Temperature measurement units	F, °C
Certification	EN 61326-1:2006 EN 61326-2:2006 EN/IEC 61010-1: 2001 EN 60825-1 Class II
Battery type	AA
Power source	Battery
Number of batteries supported	1
Operating altitude	0 - 2000 m
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Battery life	10 h

Weight and Dimensions

Depth	75 mm
Width	85 mm
Height	175 mm
Weight	255 g