68x Series
Getting Started
32
Display Configuration
The Display Configuration screen allows you to configure the automatic screen
backlight. The following parameters can be configured for Display
Configuration (the defaults are underlined):
r Backlight Timeout as 1 minute, 5 minutes, or 10 minutes.
r Auto Backlight as Disable or Enable.
Use the following procedure to configure the automatic screen backlight:
1. Press the top-level
Setup/Utils
softkey.
2. Press
E
and then the
Display Config
softkey.
3. Use
K
and
J
to set the Backlight Timeout field to 1, 5, or 10 minutes.
4. Press
L
to select the Auto Backlight field.
5. Press
K
or
J
to enable or disable the backlight function.
After you set the Auto Backlight field to
Enable
, the screen backlight turns on
for the configured timeout period and then turns off. You can then turn on the
backlight again by pressing any key. While the backlight is on, you can press
and release
H
and then press
T
to turn off the backlight. Turning off
the backlight saves battery power when the instrument is not plugged in using
the AC adapter.
After you set the Auto Backlight field to
Disable
, the screen backlight turns
off after the configured timeout period. While the backlight is off, you can
press and release
H
and then press
T
to turn on the backlight for the
configured timeout period.
To Next Page
Loading...
