Enterprise LANMeter
Attaching Cables
37
For 100BASE-TX or 10BASE-T cabling systems, select RJ-45 as the
connector type under Network Configuration, which is accessed by pressing
the
Setup/Utils
softkey. You can attach the instrument at the hub (a central
connecting point in a star-wired network) or at the station. When connecting at
the hub, use a cable connected between the hub and the instrument’s
TO HUB
connector. When connecting at the station, disconnect the station’s cable from
the station and attach it to the instrument’s
TO HUB
connector. Figure 16
shows the instrument connected to a hub.
For a ThinLAN connection, select BNC as the connector type under Network
Configuration. Attach the instrument at the T-connector. Figure 17 shows a
BNC connection.
EXIT
STOP
MORE
MENUTAB
ENTER
RUN
PRINT
HELP
ALPHA
SHIFT
ABC
789
456
123
0
•
SPACE
DEF
% UTILIZATION
HUB NIC
FRAME ERROR
BEACON
POLARITY
WIRE FAULT
LINK ACTIVE
INSERT
TRANSMIT
16 Mb/S
BNC
4 Mb/S
GHI
JKL
MNO
PQR
STU
VWYXZ
COLLISION
RING ERROR
686 ENTERPRISE LANMETER
10/100 ETHERNET
TOKEN RING
Figure 17. BNC Connection
For an AUI connection, select RJ-45 as the connector type under Network
Configuration and use a 100BASE-TX-to-AUI or 10BASE-TX-to-AUI
adapter.
To Next Page
Loading...
