Fluke 682 - Page 56

68x Series
Getting Started
48
Table 12. TCP/IP Configuration and Performance
To Do the Following Task Use This Test Under this Test
Category
Automatically have the LANMeter
instrument assist in its own IP
configuration.
IP Auto Config Internet TCP/IP
Discover IP configuration of attached
network.
Segment
Discovery
Internet TCP/IP
Analyze a troublesome IP host. Scan Host Internet TCP/IP
Analyze the path through the network that
an IP session would follow.
Trace Route Internet TCP/IP
Focus on host identification, configuration
and attached interface health and
performance.
Internet Toolkit Internet TCP/IP
Identify Duplicate IP Addresses. Segment
Discovery
Scan Host
Internet TCP/IP
Monitor the status of important user
designated IP devices.
Segment
Discovery (Key
Devices)
Internet TCP/IP
Analyze the performance of remote LAN
segments.
Internet Toolkit Internet TCP/IP
Identify the Node names of TCP/IP stations
so that the LANMeter instrument can use
names instead of Hex addresses.
Segment
Discovery
Internet TCP/IP
Verify network connectivity.
Given an IP address, find out the MAC
address.
ICMP Ping Internet TCP/IP
Identify stations by IP address that are
sending and receiving the most traffic.
Top IP (Top
Senders and
Top Receivers)
Internet TCP/IP
Identify misconfigured routers and hosts.
Find congested routers and gateways.
Locate routing loops.
ICMP Monitor Internet TCP/IP
Find route to an IP host. Trace Route Internet TCP/IP
Analyze IP traffic flow for router load
balancing.
IP Matrix Internet TCP/IP