Fluke 753 - Save to and Recall from the Registers; Use the Calculator to Set the Source Value; Quick Guide to Applications

753/754
Users Manual
88
Save to and Recall from the Registers
When the Product is in calculator mode, the top half of the
display shows three register names and their contents:
• MEASURE (the present measured value)
• SOURCE (the present sourced value)
• REGISTER (temporary storage for your use)
Push the Recall softkey and then the softkey for the
applicable register to insert the contents of any register into
a calculation.
Push Store to copy the number from the calculator display
(lower half) into REGISTER to temporarily save the number
for later use, or into SOURCE.
Use the Calculator to Set the Source Value
When you store to SOURCE, the Product shows a selection
of unit multipliers when necessary (for example, mV or V),
then starts sourcing that value. The Product will not keep
out-of-range values to SOURCE.
Quick Guide to Applications
The subsequent figures show test lead connections and
which Product functions to use for many different
applications.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca