Fluke 753 - Pressure Measurement; Source Mode Operations; Source Electrical Parameters

Documenting Process Calibrator
Measure Mode
33
Differential
HighLow
15 PSID/G
BURST PRESSURE 45 PSIG
PRESSURE MODULE
700 P 04
1 bar100 kPa
RANGE
Gage
RANGE
100 PSIG
BURST PRESSURE 300 PSIG
PRESSURE MODULE
700 P 06
7 bar700 kPa
gks11f.eps
Figure 13. Gage and Differential Pressure Modules
Caution
To prevent possible damage to the Product or
to equipment under test:
• Never apply more than 10 ft.-lb. of torque
between the pressure module fittings, or
between the fittings and the body of the
module.
• Always apply correct torque between the
pressure module fitting and connecting
fittings or adapters.
• Never apply pressure above the rated
maximum printed on the pressure module.
• Use the pressure module only with
specified materials. See the printing on the
pressure module or the pressure module
instruction sheet for the acceptable
material compatibility.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca