753/754
Users Manual
46
Note
If sourcing frequency, respond when the Product
asks you to select a zero-symmetric sine or
positive square wave. The amplitude specified is
p-p amplitude.
4. To change the output value, record a new value and
push .
Note
If sourcing current, wait for the
g
symbol to
disappear before you use the output.
5. To set the output value in the present source function,
push then enter the desired value and push .
6. To turn off sourcing completely, push twice.
Note
Use the source current function to drive a current
loop. This is different than the loop power function
in which the Product is powering a process
instrument. To source loop power, use the Loop
Power function accessible from Setup mode.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca
To Next Page
Loading...
