Fluke 8010A User Manual

3.
Install a
new fuse of the
same
size and rating. Make
sure
the
new fuse is centered
in
the fuse holder.
4. Ensure that the
case
top rotary
switch
and circuit board
switch
are
in the
OFF
position.
5.
Replace the case top, ensuring
that the gasket is
prop-
erly
seated,
the battery leads
are
properly dressed, and
the two snaps on
the case top
(at
the end near the LCD)
are
engaged.
Reinstall
the three screws.
Service
If the meter fails, check the
battery
and fuse(s)
and replace as
needed.
If the
meter
still does not
work
properly,
review this
manual to make sure
you
are
operating it correctly. If the meter
still
malfunctions, pack it securely in
its original shipping
container and forward
it,
postage
paid, to the nearest Service
Center.
Include a description of the
malfunction. Fluke
assumes NO
responsibility
for damage in transit.
MAINTENANCE
Service
A meter under warranty will be promptly repaired
or
replaced
(at Fluke's
option) and
returned
at no charge.
See the registra-
tion card for
warranty
terms. If the warranty has lapsed, the
meterwill be repaired
and
returned for
a
fixed fee. Contact
the
nearest
Service Center for
information
and prices.
A
list
of U.S.
and international
service centers
is
at the back of this manual.
REPLACEMENT
PARTS
NOTE
A njl
When servicing
the
meter, use
only the
replacement
parts
specified.
Replacement
parts
are
shown in Figure
6
and listed in Table 6.
To order replacement
parts
in
the USA, call
1-800-526-4731.
To order outside the
USA, contact the nearest
Service Center.
31

Fluke 8010A Specifications

General

Brand	Fluke
Model	8010A
Category	Multimeter
Language	English