867B/863
Users Manual
3-6
Table 3-1. General Features (cont)
Number Example Name Description
11
F
Frequency
Key
Swaps primary and secondary displays. The frequency measurement type
(usually Hz) now occupies the primary display and the Frequency Softkeys
are active. You can now select a different frequency type with the softkeys.
Press
F
again to swap the primary and secondary displays back,
retaining the most recent frequency type.
12
d
Display
Mode Key
Press to access the Display Mode Softkeys at any time. For volts and
amps functions, you can now select Combo, Meter, View, or Trend. Ohms
offers Meter or Trend. Other selector functions offer only Meter, while
LOGIC, COMPONENT Test, and SET UP use their own unique display
modes.
13
RS-232
Optical Port
Connect the RS-232 serial interface cable here for communications with a
PC or printer.
14
B
Battery
Eliminator
Connection
Connect the battery eliminator for ac operation. A NiCd battery pack
installed in Model 867B charges whenever the battery eliminator is
connected.
15
Calibration
Seal
Do not open this protective seal. Refer to the Service Manual.
To Next Page
Loading...
