Fluke 863 - Saving Screen and Configuration

Using Save, Recall, Print, and Set Up
Saving Screen and Configuration
6
6-3
P
Save
>
Screen
>
Recall Print
Save
>
Config. Exit
1
(Save Screen) accesses the Save Screen
softkeys, which allow you to save the present display
to a memory location. (Model 867B only.)
2
(Recall) accesses the Recall softkeys, which
allow display of a memory location.
3
(Print) prints the display. “Freeze” changes to
“Printing”, then reverts to “Freeze” when printing is
complete. You can stop printing by pressing
3
(Stop Print) or
5
(Exit); other keys are ignored.
4
(Save Config.) accesses the Save Config.
softkeys.
5
(Exit) (or pressing
P
again) returns to the
original display. You must press one of these two
keys to return; other keys do not operate during the
Freeze display.
Saving Screen and Configuration
(Model 867B only)
Save
>
Screen
][
Save Clear Exit
1
and
2
(
[
and
]
) select the Memory
location. Basic information (a reading, etc.) is
displayed with the title for each memory location.
3
(Save) saves the displayed information and
supporting configuration (message appears), then
returns to the Save/Print display.
4
(Clear)) erases this memory location. (“Clear”
appears only if something is saved in this memory
location.)
5
(Exit) (or pressing
P
again) returns to the
Save/Print display.