Fluke 863 - Setting up the Time Base

Using View and Trend Display Modes
Setting Up the Time Base
5
5-3
5
(Full Auto) selects the range, trigger level, and
time base automatically to produce an optimum
display of the waveform.
Setting Up the Time Base
Time
>
Base
>
Trigger
Single
>
Shot
Glitch
>
Capture
Full
Auto
Select “Time Base” (
1
) from the View Mode
Softkeys, then use the Time Base Softkeys as
follows:
Slower Faster Exit
2
(Slower) selects the next longer time per
division. More waveform activity then appears in one
time division, effectively zooming out on the
waveform.
3
(Faster) selects the next shorter time per
division. Less waveform activity then appears in one
time division, effectively zooming in on the
waveform.
5
(Exit) returns to the View display.
5 s
4.2 μs
8.3 μs
20 μs
50 μs
100 μs
200 μs
500 μs
1 ms
2 ms5 ms
10 ms
20 ms
50 ms
100 ms
200 ms
500 ms
1 s
2 s
2 3
Slower
Faster
rita0710.eps
Figure 5-1. Time Base Selection