8845A/8846A
Programmers Manual
100
Table 34. Ethernet/IEEE-488 Configuration Errors
Error Code Error Text Description
560 GPIB fatal error A fatal error occured opening the GPIB port.
570 GPIB primary address An error occured attempting to set the GPIB primary address.
572 GPIB Read An error occurred while attempting to read characters from the
GPIB port.
580 EDVR GPIB - DOS Error.
581 ECIC GPIB - Specified GPIB Interface Board is Not Active Controller.
583 EADR GPIB - Interface Board has not been addressed properly.
584 EARG GPIB - Invalid argument.
585 ESAC GPIB - Specified GPIB Interface Board is not System
Controller.
586 EABO GPIB - I/O operation aborted (timed out).
587 ENEB GPIB - Non-existent GPIB board.
588 EOIP GPIB - Routine not allowed during asynchronous I/O operation.
589 ECAP GPIB - No capability for operation.
590 EFSO GPIB - File System Error.
591 EBUS GPIB - Command byte transfer error.
592 ESTB GPIB - Serial poll status byte lost.
593 ESRQ GPIB - SRQ stuck in ON position.
594 ETAB GPIB - Table problem.
801 ENET Port number Port value is out of range (1024 to 65535).
802 ENET Server Could not open the ethernet port.
803 ENET Timeout Time-out occured while opening the ethernet port.
To Next Page
Loading...
