Fluke 8846A - Page 58

8845A/8846A
Programmers Manual
48
Examples FILT ON Turns the analog dc filter on.
Query FILT? Returns the analog dc filter setting.
Note
Since the corner frequency of the analog filter is about 8 Hz, the filter does
not add much rejection until frequencies are significantly higher than that.
[SENSe:]FILTer[:DC]:DIGital[:STATe](?) <n>
Description Activates or deactivates the digital averaging filter to improve noise
immunity for dc functions. This setting is stored in volatile memory.
Parameters <n> = OFF or 0 Turns the digital averaging filter off.
ON or 1 Turns the digital averaging filter on.
Examples FILT:DIG ON Turns the digital averaging filter on.
Query FILT:DIG? Returns the digital averaging filter setting. (0 =
OFF and 1 = ON)
[SENSe:]VOLTage[:DC]:FILTer[:STATe](?) <n>
Description Activates or deactivates the 3-pole analog filter to improve noise immunity
for dc voltage functions. This setting is stored in volatile memory.
Parameters <n> = OFF or 0 Turns the analog dc voltage filter off.
ON or 1 Turns the analog dc voltage filter on.
Examples VOLT:FILT ON Turns the analog dc voltage filter on.
Query VOLT:FILT? Returns the analog dc voltage filter setting.
[SENSe:]VOLTage[:DC]:FILTer:DIGital[:STATe](?) <n>
Description Activates or deactivates the digital averaging filter to improve noise
immunity for dc voltage functions. This setting is stored in volatile
memory.
Parameters <n> = OFF or 0 Turns the digital averaging filter off.
ON or 1 Turns the digital averaging filter on.
Examples VOLT:FILT:DIG ON Turns the digital averaging filter on.
Query VOLT:FILT:DIG? Returns the digital averaging filter setting. (0 =
OFF and 1 = ON)
[SENSe:]CURRent[:DC]:FILTer[:STATe](?) <n>
Description Activates or deactivates the 3-pole analog filter to improve noise immunity
for dc current functions. This setting is stored in volatile memory.
Parameters <n> = OFF or 0 Turns the analog dc current filter off.
ON or 1 Turns the analog dc current filter on.
Examples CURR:FILT ON Turns the analog dc current filter on..
Query CURR:FILT? Returns the analog dc current filter setting. (0 =
OFF and 1 = ON)