HVAC Clamp Meter
Maintenance
5
Maintenance
XWWarning
To avoid possible electric shock or personal injury, repairs or servicing not
covered in this manual should be performed only by qualified personnel.
Note
When the Meter displays CAL, the unit will lock and no measurements can be made. The Meter must be
sent to a Fluke Service Center for repair.
Cleaning the Meter
XWWarning
To avoid electrical shock, remove any input signals before cleaning.
W Caution
To avoid damaging the Meter, do not use aromatic hydrocarbons or chlorinated
solvents for cleaning. These solutions will react with the plastics used in the
Meter.
Clean the instrument case with a damp cloth and mild detergent.
Replacing the Batteries
XWWarning
To avoid false readings that could lead to possible electric shock or personal
injury, replace the batteries as soon as the low battery indicator (B) appears.
Disconnect the test leads before replacing the batteries.
To replace the batteries, see Figure 1:
1. Turn the rotary switch to “OFF” and remove the test leads from the terminals.
2. Use a Phillips screwdriver to loosen the battery compartment door screw, and remove the door from
the case bottom.
3. Remove the batteries.
4. Replace the batteries with two new AA batteries observing correct polarity.
5. Reattach the battery compartment door to the case bottom and tighten the screw.
To Next Page
Loading...
