Need help?Do you have a question about the Fluke 9103 and is the answer not in the manual?
General| Category | Test Equipment |
|---|---|
| Model | Fluke 9103 |
| Display | LCD |
| Temperature Range | –25 °C to 140 °C |
| Accuracy | ±0.25 °C |
| Resolution | 0.1 °C |
Lists international electrical symbols used in the manual.
Provides essential safety guidelines and definitions for warnings and cautions.
Lists authorized service centers for product support and coordination.
Details operating range, accuracy, stability, resolution, and power requirements.
Outlines safe operating conditions including temperature, humidity, and pressure.
Instructions for unpacking the instrument and verifying components.
Guidance on placing the calibrator and connecting the power cord.
Steps for plugging in and turning on the instrument.
Procedure for setting the desired temperature set-point using front panel keys.
Describes the components and connectors on the rear of the calibrator.
Details the controller display, keypad, and button functions.
Explains the aluminum block assembly that provides a stable temperature environment.
Describes the interchangeable probe sleeves for fitting various probe diameters into the well.
Instructions on how to switch temperature display between Celsius and Fahrenheit.
Explains how TEDs are controlled to maintain constant temperature.
Managing well temperature, set-points, units, and programmable memories.
Utilizing scan rate, display hold, and switch wiring for testing.
Accessing secondary menu, TEDs, proportional band, operating, and serial interface parameters.
Understanding and adjusting R0, ALPHA, DELTA, and BETA calibration parameters.
Configuring wiring, setup, BAUD rate, sample period, duplex mode, and linefeed.
Serial operation and a list of commands for controlling the calibrator remotely.
Procedure for inserting a probe and comparing its temperature to the calibrator display.
Factors affecting stabilization time and achieving accuracy during calibration.
Selecting calibration points and following the step-by-step procedure to adjust parameters.
Identifying and resolving common instrument problems and error messages.
Information regarding European directives (EMC, Low Voltage) compliance.
To Next Page
