Fluke 923 - Velocity Alarm

923
Users Manual
16
Velocity Alarm
The velocity alarm starts if the measurement is above the alarm
user preset. When the alarm goes off, the Product base vibrates
and beeps one time per second. The alarm can also be turned off.
To set the velocity alarm:
1. Push .
2. Push  to access the Set Alarm function.
3. Push  to turn the alarm on or off.
4. Push .
5. If the alarm is turned on, push  and  to increase or
decrease the alarm setting.
6. Once the correct setting shows, push .
ALARM shows on the display if the alarm is active when in velocity
mode. The alarm position is kept and stays active until the alarm is
stopped. If the Product is turned off the alarm adjustments are
kept.
Clear All
To clear all stored readings:
1. Push .
2. Push (Clear All). The Product asks “Clear All?”.
3. Push . Notice that the Samples indicator changes to 0.
The stored readings have been cleared.