DSX CableAnalyzer
Users Manual
ii
Chapter 2 How to Certify Twisted Pair Cabling
Make Sure Your Tester is Ready to Certify Cabling ..... 29
Set the Reference ........................................................... 30
Settings for Twisted Pair Tests ....................................... 31
How to Do an Autotest .................................................. 36
“Bad Patch Cord” Message ............................................ 38
Twisted Pair Autotest Results ........................................ 39
PASS*/FAIL* Results ................................................. 40
WIRE MAP Tab ......................................................... 40
PERFORMANCE Tab ................................................. 42
Frequency-Domain Results ...................................... 43
How to Save Frequency-D
o
main Results
as a Plot or a Table ............................................ 43
DIAGNOSTIC Tab ...................................................... 48
Chapter 3 Test Results
View Saved Results ......................................................... 49
How to Replace a Saved Result that Failed .................. 52
Delete, Rename, and Move Results ............................... 52
Manage Results on a Flash Drive ................................... 54
Upload Results to a PC ................................................... 55
View the Memory Status ............................................... 57
Chapter 4 Projects
Why Use Projects? .......................................................... 59
Set Up a Project .............................................................. 60
The PROJECT Screen ....................................................... 60
The CABLE ID SETUP Screen ........................................... 63
About Next ID Sets ......................................................... 63
Manage Projects on a Flash Drive ................................. 66
To Next Page
Loading...
