Need help?Do you have a question about the Fluke ESA609 and is the answer not in the manual?
General| Category | Electrical Safety Analyzer |
|---|---|
| Model | ESA609 |
| Resistance Resolution | 0.1 Ω |
| Test Voltage | 500 V DC |
| Display | LCD |
| Mains Frequency | 50/60 Hz |
| Current Measurement Range | 0 to 20 A AC |
| Resistance Accuracy | ±(2% rdg + 1 digit) |
| Leakage Current Range | 0 to 20 mA |
| Leakage Current Tests | Earth Leakage, Enclosure Leakage, Patient Leakage |
| Leakage Current Ranges | 0 to 20 mA |
| Leakage Current Resolution | 0.1 μA |
| Leakage Current Accuracy | ±(2% + 2 dgt) |
| Applied Parts | Type CF |
| Power Supply | AC mains |
| Mains Voltage | 100 to 240 V AC |
| Battery Life | 8 hours (typical) |
Guidelines for connecting the Analyzer to a grounded power source safely and correctly.
Procedure for measuring the mains voltage input to the Analyzer.
Steps to measure the impedance of the protective earth connection for safety verification.
Method for measuring the current drawn by the device under test (DUT).
Procedure to measure current flowing in the DUT's protective earth circuit.
Steps to measure current flowing between the DUT's enclosure and protective earth.
Procedure to measure leakage current between exposed surfaces and mains earth.
How to perform resistance and low current measurements between two points on the DUT.
To Next Page
