Electrical Safety Analyzer
Safety Information
3
Warning
To prevent possible electrical shock, fire, or
personal injury, follow these guidelines:
• Read all safety information before you use
the Product.
• Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
• Do not connect to live output terminals.
The Product can supply voltages that can
cause death. Standby mode is not
sufficient to prevent electrical shock.
• Do not apply more than the rated voltage,
between the terminals or between each
terminal and earth ground.
• Limit operation to the specified
measurement category, voltage, or
amperage ratings.
• Use Product-approved measurement
category (CAT), voltage, and amperage
rated accessories (probes, test leads, and
adapters) for all measurements.
• Measure a known voltage first to make
sure that the Product operates correctly.
• Use the correct terminals, function, and
range for measurements.
• Do not touch voltages > 30 V ac rms, 42 V
ac peak, or 60 V dc.
• Do not use the Product around explosive
gas, vapor, or in damp or wet
environments.
• Do not use the Product if it is damaged.
• Disable the Product if it is damaged, by
removing the power cord and fuses.
• Do not use the Product if it operates
incorrectly.
• Examine the case before you use the
Product. Look for cracks or missing
plastic. Carefully look at the insulation
around the terminals.
• Do not use test leads if they are damaged.
Examine the test leads for damaged
insulation, exposed metal, or if the wear
indicator shows. Check test lead
continuity.
• Use this Product indoors only.
To Next Page
Loading...
