Fluke Expert Series - Streaming Video (Remote Display); Stream Live to a PC

Expert Series Thermal Imagers
Streaming Video (Remote Display)
41
3. On the website:
a. Select a language from the drop down box.
b. Enter your information and the serial number from the display on the Imager. The serial
number is case sensitive.
c. Click on Submit.
If the radio is authorized in your country, an authorization code appears on the web page.
Note
If the radio is not yet authorized in your country, Fluke will contact you when the
radio is authorized for use in your country.
4. On the Imager,
a. Push  or tap Enter Code.
b. Type in the authorization code from the website. (The authorization code is not case
sensitive.)
c. Push  or Done.
A message appears on the Imager display that shows the wireless communication is
enabled.
If a message appears that says the authorization code is invalid:
• Make sure you entered the correct serial number from the Imager into the website.
• Make sure you entered the correct authorization code from the website into the Imager.
d. Tap Ok.
Streaming Video (Remote Display)
The Imager can stream live infrared and IR-Fusion technology video to a PC that has
SmartView software installed, to the Fluke Connect app (where available), or to an HDMI
compatible device.
Stream Live to a PC
To stream live to a PC through a USB connection:
1. Install the latest version of the firmware on the Imager. See Download Firmware.
2. On the PC, open the SmartView software.
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com