Battery Replacement
For specified battery life, use an alkaline battery. To replace the battery, see Figure 1.
Figure 1. Battery Replacement
If the Current Clamp Does Not Work
Storage
During long periods of non-use (>60 days), remove and store the battery separately.
Cleaning
Periodically wipe the case with a damp cloth and mild detergent. Do not use
abrasives or solvents.
Service and Parts
The Current Clamp should be serviced only by a qualified service technician. For
service information, contact your nearest Fluke dealer or service center.
Safety Specifications
Maximum voltage between any Terminal
and Earth Ground....................600 V
Temperature
Operating ..............................-10 °C to 50 °C
Storage .................................-20 °C to 60 °C
Relative Humidity ....................0 % to 90 % (10 °C to 30 °C)
0 % to 75 % (30 °C to 40 °C)
0 % to 45 % (40 °C to 50 °C)
Operating Altitude ...................2000 m
Storage Altitude ......................12 000 m
Battery Type ............................9 V (alkaline) IEC 6LR61
Battery Life ..............................60 hr typical (continuous with alkaline)
Current x Hz Product ............... ≤240 000
Output Signal...........................1 mV/amp dc or ac
Maximum Conductor
Diameter...................................1 ea: 30 mm
2 ea: 25 mm
Check Correction
Battery = OK? See Battery Test
Voltmeter connections? Red to + or Black to COM
Voltmeter function/range? mV dc/mV ac (or V ac)
To Next Page
Loading...
