Fluke ii900 - File Transfer and Firmware Updates

ii900/ii910
Users Manual
16
7. When the area of interest clearly shows, push the Capture
button. The Imager saves the image to memory.
Tip: Sound signals reflect, particularly on smooth and flat
surfaces. In certain conditions, the Imager shows a steady spot on
the source of noise and one or more steady spots from the
reflections. Move the Imager around to help discriminate the sound
source from the reflections. The sound source remains in the same
location, while reflections will move.
Use folders to organize your files. New file captures save to the
folder name that shows on the display. You have the option to
review files by folder name or timestamp.
To select a folder or create a new folder name:
1. Tap on the folder name that shows at the bottom of the
display.
A list of folder names pops up with the option, Create Folder.
2. When you select Create Folder, use the keyboard to input a
new file name.
For more information about how to view the images in memory,
see Memory.
File Transfer
To transfer saved files from the Imager to a PC:
1. Use the provided USB cable to connect the Imager to the PC.
A USB drive is added to the list of drives on your PC.
2. Open the added USB drive to view the saved images or video
files.
3. Copy the files you want to the local PC drive.
4. When transfer is complete, remove the USB drive from your
PC.
Firmware Update
Firmware updates are available for the Imager. Connect the
Imager to Fluke Connect Desktop or go to www.fluke.com
to find
the most current firmware version.
To update with Fluke Connect Desktop:
1. Use the provided USB cable to connect the Imager to a PC
with the current version of Fluke Connect Desktop software
installed.
Fluke Connect Desktop software detects the connected
Imager, checks the firmware version, and updates the Imager
if a newer firmware version is available.
Fluke Connect Desktop requires an Internet connection to
download a new firmware version.
The Imager shows a popup message to confirm the update.
2. Tap YES to confirm and start the firmware update.
The Imager shows a popup message to restart the Imager.
3. Tap YES to restart the Imager.