MDA-550/MDA-510
Users Manual
24
When the test tool is turned off, an active Report is closed
automatically.
For copying or deleting stored reports:
1. Push .
2. FILE OPTIONS.
3. Use to highlight COPY to copy to USB, MOVE
to USB and delete, RENAME to rename the report
name or DELETE to delete the report.
4. Push .
5. Use to highlight the report.
6. Push to confirm.
Successive saved screens are represented by the last 2
digits in the filename. As an example, when SAVE TO
REPORT is selected for the second time in the Motor Drive
Output, Voltage Modulation, Phase-Phase mode, the
filename is OUVMPP02.PNG.
Table 2 shows the filenames that correspond to the
selected function.
FlukeView 2
Refer to the section Connecting to a Computer in the Fluke
190 Series II Users Manual for information about how to
connect the USB cable to a computer.
The setup program of the FlukeView 2 for ScopeMeter Test
Tools is available on the USB drive included with the
Product.
After installation:
1. Start the FlukeView 2 software.
2. Push HELP to access the documentation for the
program.
To Next Page
Loading...
