Need help?Do you have a question about the Fluke MICROSCANNER and is the answer not in the manual?
Select the desired test mode, choosing from WIREMAP, OFFICE IDENTIFIER, LENGTH, or TONER.
Initiates calibration mode by holding MODE while pressing ON to set cable length calibration.
Select the desired test mode, choosing from WIREMAP, OFFICE IDENTIFIER, LENGTH, or TONER.
Initiates calibration mode by holding MODE while pressing ON to set cable length calibration.
General| Length Measurement | Yes |
|---|---|
| Wiremap | Yes |
| Wiremap Display | Graphical |
| Tone Generation | Yes |
| Cable Types | Twisted Pair |
| Display | LCD |
| Power Source | Battery |
| Fault Types | Open, Short, Split Pair |
| Connectors | RJ45 |
To Next Page
