Fluke QA-ES III User Manual

QA-ES III
Getting Started Manual
18
Power
Ranges ............................ 0.0 W to 99.9 W
100 W to 500 W
Accuracy ...................... < 10 W: ±5 % + 1 W
≥10 W: ±5 %
Maximum
At 25% duty cycle (10 seconds on,
30 seconds off) ........... 10 Ω: 300 W,
20 Ω to 2900 Ω: 400 W,
3000 Ω to 5200 Ω: 200 W
At 10% duty cycle (5 seconds on,
45 seconds off) ........... 10 Ω: 300 W,
20 Ω to 2400 Ω: 500 W,
2425 Ω to 2900 Ω: 400 W,
3000 Ω to 5200 Ω: 200 W
Current
RMS ........................... 0 mA to 5,500 mA
Accuracy ..................... ±(2.5 % of reading + 1 mA)
Voltage
Peak .......................... 10 kV Peak to Peak
Accuracy ..................... ±(10 % of reading + 50 V)
Crest Factor ........................ 1.4 to 16.0
Defined as the ratio of Peak voltage to RMS voltage (Vpk /
Vrms), using the larger of the 2 peaks (positive or
negative)
Vessel Sealing Measurement
Loop Current, RMS ............. 0 mA to 5500 mA
Accuracy ............................ ±(2.5 % of reading + 1 mA)
HF Leakage Current
Fixed Load .......................... 200 Ω
Load Accuracy .................... ±2.5 %
Power rating ........................ 400 W
Additional Fixed Load ......... 200 Ω
Current, RMS ...................... 0 mA to 5500 mA
Accuracy ............................. ±(2.5 % of reading + 1 mA)
CQM Test (Contact Quality Monitor)
Resistances ........................ 0 Ω to 475 Ω (by 1 Ω)
Accuracy ............................. 0 Ω to 10 Ω ±0.5 Ω,
11 Ω and above ±5 %
Power rating ....................... 0.5 W
Auto Time interval ............... 1 second to 5 seconds
Oscilloscope Output
1 V per ampere of input current, typical.
Footswitch Simulations
Cut and Coag
Communications
USB Device Port ................. Micro B connector
Full speed
Wireless Port ...................... 802.15, Speed:115,200 baud
Memory
Test Records ...................... 5,000
Non-volatile ........................ retained through power cycling
Calibration
Traceable to the International System of Units (SI) through the
appropriate National Metrology Institutes such as NIST or
through intrinsic standards.

Fluke QA-ES III Specifications

General

Brand	Fluke
Model	QA-ES III
Category	Measuring Instruments
Language	English