Fluke TiR2 - Set IR Fusion Blend Level; Capturing an Image

TiR2,TiR3,TiR4,Ti40,Ti45,Ti50,Ti55
Users Manual
1-10
Set IR Fusion Blend Level
Note
Fusion blending is disabled with optional 10 and 54-mm lenses.
Cameras TiR2, TiR3, TiR4, Ti45, Ti50, and Ti55 allow fusion level blending
with a few simple steps.
1. Press and hold G until the IR Fusion blend level dialog box appears on
the display screen.
2. While continuing to press G, use the mouse controller shown in
Figure 1-7 to slide the IR Fusion blend level bar in the dialog box to the
desired setting.
3. Tap the trigger button (
) to retain settings.
F2
F1
F3
Level & Span
Mouse Controller
eii007.eps
Figure 1-7. Setting the Fusion Blend Level
Capturing an Image
1. Tap once (shown in Figure 1-8) to pause the live image.
2. Review the image and camera settings.