Fluke TiR2 - Adjusting IR-VL Fusion Blend Level

Visible Light Camera Module (VLCM)
Adjusting IR-VL Fusion Blend Level
5
5-3
Adjusting IR-VL Fusion Blend Level
Note
This feature is not available on the Ti40 and is disabled with optional
10 and 54-mm lenses.
You can change the IR Fusion blend level from full infrared (IR) to full visible
light (VL) or some combination in between. When the IR Fusion blend level is
set to full IR, 100% of the image is IR. When the IR Fusion blend level is set
to full VL, 100% of the image is VL. When the IR Fusion blend level is set
somewhere in the middle of full IR and full VL, an appropriate amount of the
image is IR and an appropriate amount is VL, thus displaying a fused—or
blended—image.
To adjust the IR-VL Fusion blend level using the level & span button and
mouse controller:
1. Press and hold G until the IR Fusion level dialog box appears near the
bottom of the screen.
2. While continuing to hold G, move the mouse controller left or right to
desired setting, or use E to position the pointer over the Full IR or Full
VL text to quickly move to 100% infrared or 100% visible light
respectively.
3. Tap
to accept setting change and return to scan target mode.
To adjust the IR-VL Fusion blend level from the popup menu:
1. Tap F.
2. Use the mouse controller to position the pointer over Camera Settings on
the popup menu and tap E.
3. Position the pointer over the VLCM tab and tap E.
You may need to position the pointer over the right or left arrow on the tab
bar and tap E to scroll to the VLCM tab.
4. Position the pointer over the Full IR/Full Visible bar; press and hold E
and then move the mouse controller left or right to desired setting.
5. Tap
to accept setting change and return to scan target mode.