Fluke TiR2 - Page 74

TiR2,TiR3,TiR4,Ti40,Ti45,Ti50,Ti55
Users Manual
6-10
3. Use the mouse controller to position the pointer over Camera Settings on
the popup menu.
4. Tap E.
5. Position the pointer over the Locale tab and tap E.
6. Position the pointer over either the PAL or NTSC video signal radio
button and select. The black circle indicates setting is enabled.
7. Position the pointer over the Power tab and select.
8. Position the pointer over the Video Output Enabled button and select. A
check mark indicates function is enabled. When not in use, disable this
function to conserve battery power.
9. Tap
to accept setting change and return to scan target mode.