Calibration
Calibration
5
5-1
Section 5
Calibration
5.1 Calibration
The probe adapter modules carry the calibration data for the instrument. If the unit is shipped with a
probe, the module is calibrated at the factory prior to shipment; otherwise, the module is shipped
uncalibrated. The instrument itself does not require calibration.
If required, calibration data stored in the probe adapter may be changed using the optional
Communicator, P/N 190-1A. Refer to the instruction manual supplied with the Communicator for further
instructions and specific procedures for entering calibration data.
Avoid indiscriminately mating probes with an
adapter module; otherwise damage to the
instrument or probe or loss of stored calibration
factors, parameters, and other operational
information may occur. Fluke Biomedical
recommends the use of heat shrink tubing to
permanently connect the probe and adapter.
CAUTION
To Next Page
Loading...
Need help?
General
