Visual IR Thermometer
Maintenance
17
Charge Batteries
W Caution
To p reve n t d a m a g e t o t h e M e t e r :
Do not store the batteries in extremely cold environments.
Do not attempt to charge the batteries in extremely cold environments.
~ W Caution
Do not incinerate the Product and/or battery.
Before you use the Meter for the first time, charge the battery for at least 2.5 hours. The battery
status is displayed in the upper-right corner of the screen.
Note
New batteries are not fully charged. Two to ten charge/discharge cycles are necessary
before the battery charges to its maximum capacity.
Note
Make sure that the Meter is near room temperature before you connect it to the charger.
See the charging temperature specification. Do not charge in hot or cold areas. When you
charge in extreme temperatures, battery capacity might be decreased. When you charge
in extreme temperatures, the battery might not charge.
To charge the battery with the Type C port on the Meter:
1. Connect the ac power adapter to an ac wall outlet and connect the other end to the ac power
socket on the Meter.
The battery status icon on the screen shows that the battery is charging.
2. Charge until the battery status icon on the screen shows that the battery is full.
If you remove the Meter from the charger before a full charge shows, it can have a reduced
run-time.
3. Disconnect the Type C port when the smart battery is fully charged.
W Caution
To prevent damage to the Meter, do not use a USB charger that supplies >5 V (±5%).
To Next Page
Loading...
Need help?
General
