HYDRO TECH PERFORMANCE MONITOR
ADVANCED FILTRATION SYSTEM
www.fluval-g.com
EN.19
20
.Oncethewaterisowingproperly,checkthe
aquarium water level again and, if necessary,
restore it to adequate levels.
21
. Reprogram the mechanical maintenance
schedule by going to the Operational Menu on
the front panel. Enter to access the menu, and
use the scroll key to move down to the
Mechanical Schedule option.
22
. Press Enter to highlight the schedule. Press
enter again to reset the counter.
23
. Scroll to “yes” and press enter, and the counter
will start up from zero.
24. Press Esc to leave.
25. Repeat this process in another 14 days or
sooner if the “LOW FLOW” Alert appears.
CHEMICAL FILTER MAINTENANCE
The type of chemical media used will determine
how often the chemical filter must be replaced. For
example, carbon becomes saturated quickly and
needs to be replaced once every 30 days at the very
latest. See Filter Media in the Filter Media Options
Section for more information on the recommended
types of media available.
In between monthly replacements, the chemical cup
should also be rinsed out using aquarium water to
remove any impurities.
Equipment needed: Towel, bucket.
TO CLEAN THE FILTER:
1. Unplug the filter from the electrical supply.
2. Open the cartridge
lid. The silver
AQUASTOP valve lever
must be completely up
and the black
AQUASTOP release
lever must be completely
pushed down in order to
open the lid.
If the AQUASTOP lever is not fully lifted, the valve
may still be open and cause the water to spill from
the filter when the cartridge is removed.
3. Remove the chemical filter cartridge, located on
the right (when facing the filter), by turning the
knob counter-clockwise from the “ ” position
the “ ” position.
4. Carefully lift up the cartridge so the excess water
stays in the cartridge and doesn’t spill back into
the filter. The bottom cup acts as a dirt
receptacle, and this water needs to be emptied
into a bucket or sink. DO NOT POUR THIS
WATER BACK INTO THE FILTER.
5. To avoid water spilling, place the entire cartridge
assembly inside a bucket before proceeding.
6. Release the chemical cartridge cup from the
assembly head by pushing against one of the two
marked black clips located in the middle of the
cartridge.
7. While pressing the clips, pull the cup
downwards.
To Next Page
Loading...
Need help?
General
