20. General Functions Description
(Pic 20.1)
All functions use a set of standard user interface objects.
The bottom tray can contain the following buttons:
The back buttons returns to the previous screen.
The default button sets back the current page parameters to their default values.
These 2 buttons respectively enable and disable the current function.
(Pic 20.2)
Choose one switch direction from upward direction, middle direction and downward direction
as the open status when the switches (SwA~SwH）are assigned to enable or disable functions.
The sticks(Ail、Ele 、Thro、Rud) are assigned to adjust the function rates.
The knobs (VrA ~ VrE) are assigned parameters to adjust the function rates.
The logic function needs to be defined at first when logic switches (LSW,LS1~LS3) are assigned to
enable or disable functions. Logic switches function as shown in picture 20.2
(Pic 20.3)
Yes: reset to default the current displayed function
No: no operation
Please touch the“ ”in the top right corner to get help information
Some functions require usage of 1-4 as stated in 20.02 below to enable proper control.
Some functions require usage of 1 and 4 as stated in 20.02 below to turn on or off.
Some functions require useage of 2 and 3 as stated in 20.02 below to adjust parameters.
20.01 Introduction
20.02 Switch Function Details:
20.03 Reset Function Details:
Picture 20.2 shows the default four channel aircraft structure and CH5 auxiliary structure
Pressing this icon will display screen as shown in picture 20.3
Please use this function with care, as this will reset all parameters to factory settings and you will lose
any changes you have made
When you touch this icon the turn on and turn off icons will be displayed
525
Digital proportional radio control system
To Next Page
Loading...
