21.08. Throttle Curve
21.09. Throttle Delay
(Pic 21.10)
(Pic 21.11)
Function Details:
This function enable the user to adjusts the operation curve of the aircraft throttle and make it coordinate the stick movement
and throttle output to compensate the non-linear problems of the throttle.
The 11 points (L, 2~10, H) of throttle curve can be adjusted from 0% to 100%. The horizontal dotted line displays in real time
the throttle stick position. The vertical dotted line displays in real time the position of the throttle output after the throttle curve
function has been applied. If the airplane and helicopter does not have an engine, this icon will not be displayed. This function can
be set in five conditions.
Select the desired point to set and move the wheel to modify the corresponding value afteractivating this function.
For this example 21.10: The throttle curve function is activated. Point 2 is set 20%, point 3 30%, point 4 40% and point 5
50%,point6 74.1,point 7 80%,point 8 85.5%,point 9 90.0% and point 10 95.0%. In this situation, when theposition of the throttle
below the neutral, that is (L,2~6), the acceleration of the throttle needle outputis faster than its position above the neutral ( that is
6-10, H point),V-shaped curve and “/ ” shaped curve. The two curves can be set though 3 points, 5 points, 7 points, 9 points or 11
points.
Function Details :
Throttle delay is used to reduce the response speed of throttle output and imitate turbine engine
in airbrake, which can be set from 0s to 10s. If the airplane does not have an engine, such as a glider,
this icon will not be displayed.
Move the wheel to set the throttle delay time.The red bar represents throttle stick position and the
green bar represents channelposition.
As shown in the picture21.11: The delay time is 5 seconds. There will be 5 seconds
delay when moving throttle stick from bottom side to top side. Due to 5 seconds delay, the throttle is
in the position when it is one second and it displays 20%
531
Digital proportional radio control system