21.21. Timers
(Pic 21.30)(Pic 21.29)
Model/Engine: Model timer is the total time of turning on the model.
Engine timer counts the time when throttle value exceeds the set
value. Both timers can be reset by touching 'Reset' button, and
engine timer can modify throttle value by moving wheel on the
screen.
As shown in pictures 21.31 and 21.32: When throttle exceeds
-80%, the engine timer starts to time.
Multi-purpose timer 1 and 2: Multi-purpose timer 1 and 2 can
select Up timer, Down timer, and Down then up for timing. It can
individually start, stop, and reset and you can also set a switch or
logic switch to start or stop it.
Up timer: Timing starts from 0s. It can be started, stopped and reset.
Down timer: Default count down from 1 minute, it can be modified
by moving wheel.
Down then up: Default count down from 1 minute, and it start to up t
iming after 1 minute. It can be modified by moving wheel.
As shown in picture 21.29: Make countdown time back to
beginning time you set.
As shown in picture 21.30: Down timer set to 5 minutes and
it stops now.
The race timer start, stop function can be assigned to a push button
21.22 Trainer Mode
(Pic 21.32)
(Pic 21.31)
Function Details:
This function allows you to connect 2 transmitters together using a
dedicated cable (see page 53, No.14 optional) connected to the back
interface. Once enabled, switching on the selected trainer switch will set up
the remote as the instructor and use the trainer transmitter to control the
model.
Use dedicated cable to connect two transmitters and touching trainer
mode to activate function. The trainer transmitter can control 8 channels of
learner model, and you can select stick or knob, basic function, output
channel or none. Select display servos function, push down SwE and hold it,
learner model's channels will display in real time.
Activated trainer mode function, setting Channel 1 to aileron function,
channel 5-8 is None. Learner model's channels will display. As shown in
picture 21.32.
Display servos of trainer
transmitter
Function Details:
This function is used to control time and reduce the risk of aircraft
crashing There are three choices for timing. Select Timers to set the
timers function.
537
Digital proportional radio control system
To Next Page
Loading...
