Fly Sky FS-i10 - Mixing Functions: Aileron and Rudder; 21.06. Aileron to rudder; 21.07. Rudder to aileron

21.06. Aileron to rudder
20
21.07. Rudder to aileron
(Pic 21.7)(Pic 21.6)
(Pic 21.9)(Pic 21.8)
The aileron to rudder automatically creates a coordinated turn for the aircraft
with aileron and rudder. It is the pre-programmed mix which controls the
rudders with the aileron operation and can modify the master channels rate,
which is 10% by default. If the aircraft does not have the aileron or the rudder,
these two function icons will not be displayed. This function can be set in five
conditions.
Select the desired low side or high side to set the rate and move the wheel
to modify the corresponding values after activating this function. This function
can be assigned to a switch (SwA~SwH、LSw).
For this example: The low side rate is set to 20% and the high side rate to
20% . Move the rudder stick to the far left, and the corresponding channels are
displayed as shown in picture 21.6. Move the aileron stick to the far right, and
the corresponding channels are displayed as shown in picture 21.7.
Function Details:
This function can be used to counteract undesirable roll of aircraft with
rudders and ailerons. This happens with the rudder input, when it is crabbing .
It is the pre-programmed mix which mixes the aileron with the rudder operation.
This setup can modify the master channel's rate, and the default value is 10%.
If the aircraft does not have the aileron or the rudder, these two function icons
will not be displayed. This function can be set up in each of five conditions.
Select the desired low side or high side to set the rate and move the wheel
to modify the corresponding value after activating this function. This function
can be assigned to a switch (SwA~SwH、LSw).
As shown in pictures21.8 and 21.9: The low side rate is set to 20% and the
high side rate to 20% . Move the rudder stick to the far left, and the
corresponding channels are displayed as shown in picture 21.8. Move the
rudder stick to the far right, and the corresponding channels are displayed as
shown in picture 21.9.
Aileron to the far left Aileron to the far right
Rudder stick to the far left Rudder stick to the far right
Function Details :
http://www.flysky-cn.com
30