21.19. Logic switches
switch logic relationship
Swith1 Swith2
And
Or
Xor
off
off
off off off
off off off on on
on on off on on
on on on on off
(Pic 21.28)
(Pic 21.27)
The logic switch is a virtual switch which consists of two switches plus a
mathematical logicl relationship. The logic switch is used to control turning
on or turning off of some functions two switches control one function . There
are 3 sets of logic switches (Lsw1,Lsw2, Lsw3). Select switches from SwA
to SwH to combine the logic switch. The logic relationship includes "And", Or
and " Xor". The combination is as follows
The logic switch is a virtual switch which consists of two switches plus a
mathematical logicl relationship. The logic switch is used to control turning
on or turning off of some functions
Function Details:
As shown in the picture 21.27: Select SwA up and SwB up and the logic relationship is set to or. Sw1, Sw2 and logic switch
are displayed in real time. SwA is used to lower the wheels and logic Sw1 is to cut the engine. To accomplish this you need to
access the auxilary channels screen. So, if SwA and SwB pushed down at the same time, the engines will be cut
21.20. Airplane structure
Function Details:
This function can be set according to the airplane structure.
There are engine, throttle needle, aileron, two aileron, flap, two flap, sopliler, two sopliler, rudder, two rudder, V-tail to choose
if the mode type is fix wing or glider. There will be a reminder Maximum number of channels reached. if the airplane parts selected
is more than 10. Because the two rudders and V-tail can not exist at the same time, the V-tail will be hidden automatically when two
rudders is selected. The default type is Fix wing/glider with engine, aileron, elevator and rudder.
http://www.flysky-cn.com
36
To Next Page
Loading...
