39
20
21.15. Linear mixes
21.16. Curve Mixes
(Pic 21.24)
(Pic 21.21)
(Pic 21.22)
Linear Mixes can set 4 groups of mix controls among any two sticks, basic functions and output
channels. This function can be set in five conditions.
The slave channel will be affected by corresponding rate of master channel, which will be changed in a
linear fashion after linear mix function is applied. Master channel contains stick/knob option and basic
function option or output channel option. Slave channel contains basic function option or output
channel option. But when output channel option is selected in master channel function, there is only one
output channel option in slave channel options. Otherwise, no matter what option you select in the
master channel function, any option channel could be selected in the slave channel. The master channel
and the slave channel can be assigned to sticks or knobs, basic channels or output channels. The 4
mix functions can be assigned to a switch.
Stick/knob: stick and knob from VrA to VrE.
Basic function: It is the basic function for the aircraft movement. For example: aileron function, rudder
function, throttles function, and rudder function and the throttle needle function for the aircraft structure with
the throttle needle, etc.
Output channel: CH1~Ch10;
Low side: Set how much the channel is affected by low side of master channel.
High side: set how much the channel is affected by high side of master channel.
Offset: set the deviation rate of the channel, based on the channel neutral position.
The position of the corresponding channel output is displayed in real time while adjusting the low end mix,
high end mix or offset.
As shown in picture 21.22: The first set of mix is activated, and the master channel is aileron function
and the slave channel is elevator Ch2, The low side mix is set to +50% and the high side mix is set to +
100%. Move the stick to the far left, the channel position is displayed .
(Pic 21.23)
The curve mixes like linear mixes can be set to 4 set of mixes. This function
can be set in 5 conditions..
The slave channel will be affected by master channel after linear mixes are
applied, which will be presented with curve distribution. Set 11 points (L,2~10,H)
from -100% to 100% to adjust the curve. The horizontal dotted line displays in
real time the stick position and the vertical dotted line displays in real time the
position of slave channel output after this function. The master channel and
channel can be from stick or knob, basic and output channel. These 4 sets of
mixes can be assigned to a switch(SwA~SwH、LSw) respectively.
The position of the corresponding channel output is displayed in real time
while adjusting the curve.
As shown in picture 21.23 The first mix is activated. The master channel is
aileron function and the slave channel is CH2 Ele. Adjust the value of point L
to -90%, and point H to 90. Do not adjust other points. At this time, the output
will be shown as curve in picture
Function Details:
This function could be helpful when you are flying some special movements and need mix control function
This function can be helpful when you fly with some special movements
and need some mix control function
Function Details:
http://www.flysky-cn.com
34
To Next Page
Loading...
